Extreme care is urged that all legal requirements have been met and that all installations and maintenance instructions are followed Route the sensor cable to the controller location. In addition, normally-closed safety contacts from each of the two safety switches must be individually connected to the two separate inputs of a 2-channel safety module or safety interface, as illustrated in Figure 1.
This is required to provide monitoring for safety switch contact failure, and to provide the necessary reset routine, as required by ANSI B11 and NFPA 79 machine safety standards. Confirmation that the sensor and magnet are not being used as an end stop, 4 Loosening of the sensor or magnet mounting hardware. Accessories to Complete Your System Add all or individual items to your cart. More options available below. Switch Style Non-Contact. Device Type Magnetic - Sensor. Primary Housing Material Thermoplastic.
Actuation Standard. Device Size 88 x 25 x Device Shape Rectangular. Min Op. Max Op. IP Rating IP PL Rating PL e. Safety Category Cat 4. Output Type Reed Relay. Connection Type Cabled. This is required to provide monitoring for safety switch contact failure, and to provide the necessary reset routine, as required by ANSI B11 and NFPA 79 machine safety standards.
Confirmation that the sensor and magnet are not being used as an end stop, 4 Loosening of the sensor or magnet mounting hardware. In addition, we recommend that a qualified person check for the following on a periodic Wire Connections Screw terminals with pressure plates accept wire size: 0. SW36 5.
0コメント